Airmar PB100 Technical Information download pdf (Page 20)

Auxiliary NMEA OUT Grommets

Use the AUX NMEA OUT grommets to connect one or two additional devices to

receive and display data from the WeatherStation. To wire a device(s) through the

AUX NMEA OUT grommet(s), use the NMEA OUT terminals on the printed circuit

board (see Figure 13).

Note: If you will be connecting two devices, wire both devices to the same

designated terminals—on top of one another.

1. Route the cable coming from the additional display device(s) to the Combiner.

Do not

fasten the cable in place at this time.

2. Allowing an extra 25 cm (10") for wiring ease, cut the cable to length.

3. Remove the cover of the Combiner to expose the terminals inside.

4. Using a small Phillips screwdriver, puncture the grommet(s) that corresponds to

AUX NMEA OUT on the cover (see Figure 7).

Be careful

not to damage the

circuit board.

Figure 13. Wiring additional display devices to the Combiner

AIRMAR

WEATHER STATION

25-431-01

NMEA DISPLAY

ACTIVE RESEARCH L

TD 2005

SHIELD

A/+ B/- A/+ B/- - +

A/+

NMEA IN

NMEA OUT

WER

NMEA

SHIELD

NMEA IN

NMEA OUT

POWER

NMEA

- +

B/-

A/+ B/- A/+

USB

050818-001 A

CTIS

SHIELD

PWR

GND

NMEA MULTIPLEXER

additional

display

additional

display

grommet

cable

NMEA

display

cable

power

cable

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 59 60

Comments to this Manuals

No comments

Airmar PB100 Technical Information Page 20

Comments to this Manuals

Related products and manuals for Weather stations Airmar PB100